Tools required:

- Knife for cutting clear tubing

- 12mm drill bit for outlets

- 29mm Hole Saw for rubber pumps.

- fine grit sandpaper

Instructions:

1. Hold rubbers in preferred position on push plate and neatly outline hole positions for drilling.

2. Drill 4 x holes with 29mm Hole Saw.

3. Gently sand holes to remove sharp edges.

4. Insert rubbers and fit valves to your liking.

5. See diagram for recommended layout.

6. Drill 1 or 2 12mm holes for outlets.

7. Connect all pipes and valves securely.

8. Fill boat with 5 litres of water to prime pumps and test suction.​​​